Support HYPERPLANNING-
How to administer the Server remotely?
In the network version, you can operate the following applications Controller 
, Server 
, HYPERPLANNING.net 
, HYPERPLANNING.data 
or Service Web 
from another computer than the one on which the application is installed. To do this, you use the corresponding remote administration application.
, Server , HYPERPLANNING.net , HYPERPLANNING.data or Service Web from another computer than the one on which the application is installed. To do this, you use the corresponding remote administration application.Download and install the remote administration application
The remote administration applications can be found on the application download page, HYPERPLANNING > Downloads > Download HYPERPLANNING.
- Search for the rubric HYPERPLANNING 2023 NETWORK | For Administrators.
- Download the application Administration of the SERVER.
- Install it on the workstation from which you want to administer remotely.
Authorize remote administration from the application
- Go to the panel Remote Administration from the Server .
- Tick Authorize Remote Administration.
- Verify that the port is open and change it if it is used by another application.
- Enter the address of the computer on which the remote administration application is installed.
If you want to administer remotely from several workstations, the addresses of these workstations must all be authorized. If these addresses are consecutive, leave By block ticked and choose the appropriate mask. If the addresses are not consecutive, tick By range and enter the concerned address ranges.
Configure the remote administration application
- From the remote administration application, go to the panel List of servers.
- Enter a name for the Server.
- Copy the IP address and port number from the panel Publication parameters of the application.
Was this content useful to you?
Can't find an answer to your question ?
Contact our support