Support HYPERPLANNING-
How do I prohibit some IP addresses from connecting to the Control?
By default, all IP addresses connecting to the Server and the Control are authorized and verified (blocking after incorrect authentication, limiting connections per second, etc.).
You can choose to:
You can choose to:
- keep this configuration and if necessary, prohibit certain IP addresses;
- allow only certain IP addresses.
Prohibit certain IP addresses
- From the application Controller
, go to the tab Security parameters. - Click on the tab Address management.
- Choose Verify all the addresses.
- Enter the prohibited addresses (in red):
- if there are several addresses in a row, enter the first address, then the last;
- if the addresses are not consecutive, enter as many lines as there are addresses.
- At the same time, you can define preferred addresses (in blue), on which no verification is conducted.
Only authorize some IP addresses
- From the application Controller , go to the tab Security parameters.
- Click on the tab Address management.
- Choose Prohibit all the addresses.
- Enter the authorized addresses, either as preferred addresses (in blue) or as verified addresses (in green):
- if there are several addresses in a row, enter the first address, then the last;
- if the addresses are not consecutive, enter as many lines as there are addresses.
Was this content useful to you?
Can't find an answer to your question ?
Contact our support